Note 10
Wiring method for blue/black door trigger wire
The blue/black door trigger wire (-) default setting is negative (-) door trigger
wire with jumper. See diagram as right:
Note 11:
Wiring method for fuel pump wire
The Blue fuel pump wire is recommend to connect with fuel pump wire or oil pump wire/oil pressure wire or
the sucker motor wire in your vehicle.
If you can’t find those wires, please connect it with constant 12V wire or tach wire. This wire usage is to
detect whether the car is started succeed or not & should be well connected.
Note 12:
Wiring method for purple trunk positive/negative selection wire
For the purple trunk positive/negative selection wire, if your trunk is positive t), please connect this
wire with co12V wire; if your trunk is negative(-) trigger, this wire connect with chassis ground.
White/black
Orange/black
Yellow
White
Orange
Pink
Green wire
Orange
Red
Black
Black
White
Blue/black
Blue
Green/black
Green
Purple
The 2nd row 10 pin wires
Unlocking wire, see central door locking installation
See central door locking installation
See central door locking installation
Locking wire, see central door locking installation
See central door locking installation
Output of factory horn(-)
For GPS module, not used, insulate separately
Footbrake wire(+)
+12V wire for GPS module, not used, insulate separately
Chassis ground(-)
Chassis ground(-)
For GPS module, not used, insulate separately
Negative Door trigger input wire(-)
Fuel pump wire(+)
Trunk release
Output of trunk/trunk motor
Trunk positive/negative selection wire
15A
15A, see note 16
-
300mA, see note 17
See note 10,18
Can be changed to po)
by jumper, see note 10, 18
See note 11
See note 12
See note 15
See note 15
see note 13,14
see note 13,14
1
2
3
4
5
6
trunk motor
cut off the trunk wire
Output
of
the trunk
connect with +12V wire
Purple
wire
Green wire
Green
/
black
wire
Note 13
Wiring method of negative (-) trigger of the trunk
Note 14
Wiring method of Positive (+) trigger of the trunk
If the trunk is po) trigger wire, need to cut off the trunk wire in half, the green wire is connect with the
output of the trunk wire and the green/black wire is connecting with trunk motor wire respectively. Like 8th
generation Accord of Honda, need to connect in this way.
1
2
3
4
5
6
Purple wire chassis ground
Green
wire
output
of
trunk
/
trunk
motor
Green/black wire No need to connect, insulate separately
Note 15
Wiring method of black chassis ground wire
We recommend that you do not use a factory ground. Ground all your components including the siren, to the
same point in the vehicle, (preferably the kick panel). Scrape away any paint and use a factory bolt or make
your own ground with a self-tapping screw and a star washer.
Please use a factory bolt or screw to attach all the black chassis ground wires securely as the photo show as
below:
Factory bolt chassis ground wire
-
-
12
©
EASYGUARD
Electronics
.
All
right reserved.
-11-
©
EASYGUARD
Electronics
.
All
right reserved.
Door trigger jumper, defaut is negative(-)
If your car is with positive door trigger wire, please reset it with below instruction:
a. Un-screw & open the alarm control module
b. Take out the jumper and reset it to be positive (+)
see wiring diagram as right:
door
Positive door trigger (+) setting
Once you re-set with the door trigger jumper to be positive (+), the blue/black door trigger wire is changed
to be po) now.
door
Negative door trigger(-)( by default)
