PANTONE 072 C
PANTONE 123 C
Paper weight 60gsm
• Put box to one side, saving for possible return of ladder in the unlikely event of complaint.
• Remove plastic wrapping and dispose of it responsibly.
• Please check contents of the package which, as well as these instructions, should contain:
1
x Four section multi-purpose ladder
2
x Stabiliser cross sections
8
x Set of bolts, nuts and washers
2
x Galvanised steel platforms
Thank you for purchasing the The Versatile Ladder.
Congratulations on your purchase! Your ladder has been built to the highest standards and
conforms fully to British and European Standard EN131. Great care should be taken when using
any sort of ladder. Always check stability, use good judgement and common sense in positioning,
climbing and descending the ladder and do not over-stretch from it. Give it sensible maintenance
and lubrication throughout its life.
Dear Customer
BEFORE USE
RUNGS
GALVANISED STEEL
PLATFORMS
STILES
HINGE
Diagram 2
Diagram 4 - Multiple Positions
Diagram 1
RUBBER FEET
STABILISERS
1
2
3
4
5
6
7
8
9
ASSEMBLING THE PRODUCT
1. Slide the two stabilisers into the slots at both ends of ladder, aligning holes as you do so.
2. Insert bolts, place washers then fi x and securely tighten nuts (
see diagram 2
).
3. Ensure correct positioning of the platforms: Position the platforms so that the end of each platform
overlaps an end runner on the end of each side. Then the two steel platforms will meet directly above
a rung, ensuring stability.
4.
IMPORTANT:
Make sure that two platforms are securely fastened together (
see diagram 5
)
Please Note:
If the ends meet between two rungs, you have positioned incorrectly.
OPERATION AND SAFE USAGE
• There is a release latch on each hinge clearly marked either
L
or
O
. i.e.
locked/unlock, on/off (
see diagram 3
).
• Release locks on an opposite pair on hinges and move the section(s) to
create the required position (
see diagram 4
).
• Check that locks have fully engaged when all 4 sections are in the required
positions.
• Whatever position is selected,
ALWAYS
ensure that base of ladder is on
fi rm ground and secure.
• When used as a scaffold (position 5, 6, 7, 8 & 9) the two steel platforms
must be fi xed in place (only one platform section required for position 5 & 6).
•
When using the two steel platforms together
, join the “keyhole” fi xings
(
see diagram 5
).
• The platform(s) must then be positioned between the stiles and the end
tabs aligned pointing down between rungs (
see diagram 6
).
Please Note:
Do not stand on the ladder as a platform without using the steel platforms supplied.
Ensure these are face down
between the rungs
LOCKED
UNLOCKED
Diagram 3
Diagram 5
Diagram 6
Customer service: 0871 855 6100
For more innovative products from Easylife please visit:
www.easylifegroup.com
3625 - Versatile Safety Ladder.indd 4-5
26/07/2012 17:01