EN
20
Connecting External Devices with Jack Plug (AUX IN)
PLEASE NOTE!
■
The radio and the external playback device must be switched off before they are con-
nected to or disconnected from one another. Read the operating instructions for the
playback device.
1. Make sure that the playback device and the radio are switched off. Press the
POWER
button (
10
) to switch off the radio.
2. Plug the 3.5 mm jack plug of the playback device into the
AUX IN
socket (
2
) of the
radio.
3. Switch on the designer radio by pressing the
POWER
button (
10
).
4. Keep pressing the
FUNC
button (
7
) until the
USB/SD/AUX
operating lamp (
21
) lights
up violet.
5. Switch on the playback device and control the playback via this device. The volume
can be set via the
VOLUME
control (
16
) of the radio.
Connecting Headphones
WARNING!
■
Danger of damage to hearing!
A high volume which impinges on your ears for a
lengthy period of time can cause permanent hearing damage. You should therefore
avoid constant listening at a high volume via headphones or earphones!
1. Use the volume control (
16
) to set the lowest volume.
2. Plug the jack plug of the headphones or earphones into the
PHONES
headphones
output (
1
) on the device.
3. Set the volume you want.
Cleaning and Storage
PLEASE NOTE!
■
Make sure before any cleaning that the device is switched off and not connected to
the mains power.
■
No liquid must be allowed to enter the device during cleaning. Never immerse the
device in water!
■
Do not use any corrosive or abrasive cleaning agents!
Wipe down the device with a clean, slightly damp cloth. Use mild cleaning agent if neces-
sary.
If the device is not going to be used for a prolonged period, take out the batteries and
disconnect the device from the mains power.
Store the device in a dry, clean, frost-free place that is protected from direct sunlight and
cannot be accessed by children or animals.
