9. CONTROLS
ON/ OFF Button
To switch unit ON:
Press and hold down
for 3-5 seconds.
When the unit is switched ON an audible
“Beep” will be heard.
One Touch Memory Start
When switched on the unit will automatically start in the program which
was being used when it was switched off.
The strength returns to about 50% of the level that
was being used
when the unit was switched off.
During start up to stop the increase in strength at any time, press any
key once.
To switch unit off:
Press and hold down
the button
for 3-5 seconds and the unit
will switch off.
When the unit switches OFF an audible
double
“Beep” will be heard.
Strength UP Button
To increase strength:
Press and hold
down until required strength is achieved.
Press and release to increase in soft and
gentle 00.5mA steps.
ON/OFF
Strength
DOWN
Strength
UP
Program
Timer
19
20
elise au manual Rev 3.0 5/16 artwork.indd 19-20
Note:
Always check unit is OFF before removing probe or pads.
The unit will remain in the “Work” part of the cycle for 5 seconds while the
strength is being adjusted.
