7
Threading Cold Film
Follow the diagram to thread the film:
• Slide the cold film onto the roll shaft. Hold the cold film on the core adaptor to prevent it rotating.
Screw the bolt on the core adaptor, put the roll on the brackets. Make sure both ends are fitted
securely.
• Insert a piece of guiding paper between the rollers. The width of the paper/cardboard should be
wider than the cold film. Pull the film from the roller passing over the stabilizer bar towards the
roller.
• Attach the backing paper to the take-up mandrel. Peel back the film and stick to the guiding
paper/cardboard.
The adhesive must face away from the roller.
• Close the rollers using the roller pressure hand wheel on the right hand side of the system. Press
the Forward switch, the film will begin to feed.
