long as correction level indicator is not shown as "– –" on the LCD screen (which is
the "No Transmit" mode for the transmitter).
4.2
Make sure the collar receiver is turned ON. (The collar receiver will be turned on
automatically after the charging or please refer to Step 3: Turn ON/OFF the Collar
Receiver) .
4.3
Press and hold down the power button on collar receiver firmly (you might find
it easier to hold it down firmly with finger nail), a green indicator light should come
up and stay on in the collar receiver while the button is pressed down (Please note
that the power button needs to be held down firmly until the matching up is
completed).
4.4
Short press the “
T
” button on transmitter handset. The green indicator LED light
on the transmitter will come up, which means it is sending out a command to the
collar receiver. On the collar receiver, the green LED light will start flashing on and
off (it will be a proper on and off flashing but not just a flickering) which indicates the
matching-up procedure is completed successfully.
4.5
You may now release the power button on the collar receiver and start using the
collar receiver from the registered channel.
If you find it difficult to hold down the power button on collar receiver properly
during the whole matching up procedure, you might find the following way easier to
perform the matching up:
With both transmitter handset and collar receiver turned on, send out a correction
command from the transmitter handset by short pressing the T button on the
handset. The handset will send out a command to the collar receiver and the signal
will last for 2 seconds.
WITHIN THESE 2 SECONDS
, press and hold down the power
button on collar receiver firmly (you might find it easier to hold it down firmly with
finger nail), the green LED light on collar receiver will come up and start flashing on
and off. You may now release the power button on collar receiver and the matching
up is completed.
For multi-dog training setup, simply follow the above matching-up procedures to
match up the collar receivers one by one. Each time, choose a different dog channel
for the new collar receiver.
The matching code will be stored in the receiver automatically and there is no need
to repeat the matching procedures after switching on/off or recharging the collar
receiver. *
