* If the battery inside the collar receiver has been left flat for a long period of time,
the collar receiver might lose the matching code memory. Please charge the collar
receiver and perform the matching-up procedure again.
Caution! Never perform the matching-up procedures while the collar
receiver is on your dog!
Step 5: Test the Collar Receiver
Important: We would recommend you to use warning tone or vibration correction
first before starting the static pulse stimulation. And always start at the lowest
level of stimulation and work your way up.
Please make sure the collar receiver is in fully working order before putting it on
your dog!
Let’s take Dog A collar receiver for example:
To test the vibration function,
short press the vibration button on the
transmitter and choose a valid correction level for vibration (from Level 1 to Level 10,
Level 1 is the weakest and Level 10 is the strongest)
Short press button
T
to send out command to Dog A collar receiver. Dog A collar will
start vibrating for about 2 seconds at the selected level. A green LED light on the
collar receiver should come up during this correction period.
Short press "+" or "–" to adjust the level setting of vibration correction. Short press
button T again to send out the new command. Dog A collar will start vibrating at the
newly selected level. A green LED light on the collar receiver should come up during
this correction period.
Send vibration correction command to collar
receiver:-
Short press vibration button and select a valid
correction level setting
Short press T button and a vibration command
will be sent out to the collar receiver when T
button is released
