EX3600
Reliability You Can Count On!
© 2019 EasyPro, Inc
Pg. 2
IN THE USA
ASSEMBLED
INSTALLATION
Please read carefully! When properly installed, the EX3600 will provide dependable, trouble-free service.
1. Do not submerse the unit in water — it is not a submersible pump. Do not allow the pump to become submerged during transient
periods, such as heavy rain, run-off, etc.
2. Locate the pump as near the water source as possible. A flooded suction is preferred.
3. The pump is not self-priming. Therefore, if the fluid level is below the pump, a swing check valve must be installed below water level.
The pump and inlet line must be primed prior to start up. Do not run pump dry! For non-flooded installations, a strainer basket and
check valve are recommended.
4. Mount the motor base to a secure, immobile foundation.
5. Use only plastic fittings on both the inlet and discharge ports. Seal the inlet & discharge fittings with Teflon™ pipe dope. These fittings
should be self-supported and in neutral alignment with each port (i.e., Fittings must not be forced into port alignment which may cause
premature line failure or damage to the pump volute).
6. Never restrict the inlet! Keep both inlet and discharge lines as free of elbows and valves as possible. Always use pipe of adequate
diameter. This will reduce friction losses and maximize output. Never use an inlet line of smaller diameter than the discharge line.
Minimize the suction lift.
ELECTRICAL HOOK-UP
Carefully, examine the power cord before use. Do not use this power cord if there is any visible damage. Do not use this power cord in
water or if the motor or electrical receptacle is in contact with any standing water! This power cord should only be plugged into a properly
installed 115 VAC GFI receptacle! ALWAYS TEST CYCLE A GFI RECEPTACLE TO DETERMINE ITS CONDITION BEFORE USE!
We congratulate you on your choice of the EX3600 centrifugal pump! Its leading edge design provides you with high output at a minimal
operating cost. It is carefully constructed to give you long term, reliable service. To insure proper performance, we urge you to carefully
follow the instructions in this manual. If you have any questions, please call your supplier for assistance.
PUMP
BALL VALVE
BALL VALVE
SUCTION LIFT
FLOODED SUCTION
SWING CHECK VALVE
WARNING: DO NOT RUN DRY!
WARNING: ALWAYS SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND / OR SERVICING THIS PUMP! ALL ELECTRICAL WIRING SHOULD MEET STATE AND
LOCAL ORDINANCES. NOTE: THE PUMP MOTOR IS DESIGNED FOR 115 VAC 60HZ POWER ONLY! WARNING: SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND /
OR SERVICING THIS PUMP! 230V 50HZ MOTORS AVAILABLE - CONTACT YOUR SUPPLIER FOR INFORMATION.
