15
troubleshooting your
POND MONSTA
P
oor Flow from the Pond Monsta
• Follow clearing blockages procedure on page 12. Check the hose attachment,
the motor housing and the brush head inlet for blockages like large clumps of
blanket weed, large stones, sticks or any other large pond debris.
• If the impeller has been changed, check to see that it has been correctly fitted
(see page 14).
• Ensure the outlet hose is not kinked or crushed.
• Only use smooth bore hose as hose with ridges on the inside wall will greatly
restrict flow.
• Check all air is released from air outlet.
no Power to the Motor
• The LED is glowing red on the RF receiver but there is no action when activat
-
ing the handle lever - check the batteries are correctly fitted in the remote
control handle and the handle does not have any water inside the casing. If
there is water present, place inside a warm area to let the water evaporate. If
the Pond Monsta has been used for prolonged periods the battery will need
replacing.
• The LED on the receiver are not glowing when plugged into the main circuit -
check your plug in the GFI, your fuse box or breaker box. Check fuse in three
prong plug, if needed replace and test again.
• The LED is glowing red on the receiver and turning green when the trigger on
the handle is compressed but still no action from the motor - this may indicate
that the motor has overheated, the motor will reset when cooled after fifteen
minutes.
Handle Activation Control
• Occasional loss of squeeze on, release off control is normal. Ensure line of
sight between handle and receiver, adjust hands and body position - this will
improve receiver signal reception.
Faults - Problems Procedure
Before returning your Pond Monsta to your dealer or contacting our customer
advice department, please try the following steps. This will solve most problems
quickly and easily.
1. Ensure electrical procedure has been followed fully. Check fuse and any cable
connectors or switch boxes.
NOTE - If the pump has overheated the thermal overload will temporarily
switch off pump.
2. Follow “clearing blockages” on page 12 and “troubleshooting” guide above.
3. Return pump to point of purchase for inspection and advice (you will need
proof of purchase). If there is a warranty issue please call EasyPro Pond Prod-
ucts for an RA number and shipping address at 800-448-3873.
Consumer Contact Details
EasyPro Pond Products
4385 East 110th, Grant, MI 49327
231-834-7720 • 800-448-3873
info@easypropondproducts.com • www.easypropondproducts.com
