Installation of LED Light
For a complete system you will need RGBC controller unit with remote control,
5 pin power cables with quick disconnects, optional splitters and RGB9PL
fixture(s). All items are sold separately.
1. Before installing the product, check for damaged
or missing parts. Contact EasyPro immediately if
pieces are missing or damaged.
2. Be sure the power is disconnected before installing
the light.
3. Determine desired location to place the LED light.
Note: Consider that you may need future access to
the quick plugs should a fixture need to be replaced.
4. Use with or without removable base to fit fixture into
desired location. If base is used it may need to be
ballasted to prevent fixture from shifting.
5. To connect pigtail wire from LED fixture to 5
pin corresponding power cable or splitter (sold
separately) line up the pins from the fixture’s pigtail
to the receptacle of the cable or splitter. Insert pins and secure with half-turn,
twist nut on cable or splitter. Always be sure o-ring seals are present. See
figures 1 and 2.
6. Connect power cables and/or splitters to RGBC controller (sold separately)
using quick connect plugs and receptacles. Be sure all connections are
secured with quick connectors.
7. Angle of fixture can be adjusted with screws on side of unit.
8. Plug the controller unit into a GFCI outlet. Lights will start on default mode 1.
Note: Power supply must be maintained to control module or light will default
back to mode 1 on startup.
RGBC
Controller
LKC Cable
FCR13
1x3 Splitter
FCR14
1x4 Splitter
RBG9PL
LED
RBG9PL
LED
LKC Cable
RGB9PL
Controller
FCR12
FCR13
FCR14
Cable
Figure 1
Figure 2
o-ring
