Seat Depth/Back Angle/Back Height
Caution:
Do not adjust the seat depth while the child is in the
unit
.
Caution:
Ensure the colors on the seat tube and following arm
match.
First remove the Shadow Tray and bring the seat up to a slight
angle.
FIG. H-
Loosen the knobs on the seat tube and the following arm.
Do not unscrew knobs out all the way when adjusting the seat.
The Bantam
Extra Small
back angle adjustments are located
above the locking knob. The back angle adjustments go from
green (largest) to blue (smallest).
The Bantam
Small
back angle adjustments are located below
the locking knob. The back angle adjustments go from blue
(smallest) to green (largest).
FIG. I-Adjusting to a shorter setting:
Adjust the following arm
(back angle) first by depressing the spring button and moving
no more than two holes at a time. Then adjust the seat tube
(seat depth) one hole at a time. Continue this sequence until you
achieve the desired setting and the colors on the seat tube and
following arm match.
FIG. I-Adjusting to a longer setting:
Adjust the seat tube (seat
depth) first by depressing the spring button and moving only one
hole at a time. Then adjust the following arm (back angle) no
more than two holes at a time. Continue this sequence until you
achieve the desired setting and the colors on the seat tube and
following arm match.
FIG. J-
For easier adjustment, use the back bracket as a handle.
You may need to lift slightly as the seat depth adjustment is
made.
FIG. H-
Tighten the seat depth and following arm knobs securely
when you have achieved the desired position.
FIG. K-
To adjust back height, loosen knob and slide back into
position. Tighten securely.
Shadow Tray Option
Caution:
These adjustments are only to be made while the unit
is in the seated position.
Caution:
Always support the tray when loosening the ratchet
handles to adjust the tray.
Caution:
After placing the tray into position, ensure the ratchet
handles on the side of the tray are tightened securely.
FIG. L-
To adjust the depth of the optional tray, place tray tubes
into the receptacles and line up holes to the desired depth,
and insert pins.
FIG. M-
To adjust the height of the tray, loosen both ratchet
handles and lift the tray to the user’s desired height, tighten
securely.
FIG. N-
To adjust the angle of the tray, loosen both ratchet
handles on the side of the tray and position the tray to the user’s
desired angle, tighten securely.
!
!
!
!
!
FIG. H
FIG. I
FIG. J
FIG. L
FIG. K
FIG. M
FIG. N
Following Arm
Seat Tube
Extra Small
Small
Adjustments & Usage
Page 15
