29A
29B
13 . With assistance, position the back in the slot
on the seat as shown.
14 . Line up the holes and place the wagon wheel
plastic washer between the hip pivot bracket and
the slot on the seat, insert bolt from the inside of
the unit.
Repeat these steps for the other side of the unit.
15 . Place the metal washer and lock nut onto the
bolt.
Page 5
28 . Place nuts onto bolts, remove nut caps.
Tighten nuts securely and replace caps.
29A . Run the cables inside the adjustment
wheel. Insert tie strap into hole
Note: Tie Strap will be in a bag on the controller.
29B . Do the same for the other side. Line cable
clip up with hole on unit. Insert tie strap and
tighten. Trim excessive strap and turn cut end
inward.
Do not twist cables when installing
controller .
For controller usage see pg. 23 in the
Instructions For Use manual.
30 . If the optional Shadow Tray was ordered,
place the tray upside down as shown. Flip the
chrome arms as shown, remove 4 bolts from bot-
tom of the tray. Place arm brackets onto tray and
line up holes in arm bracket with holes on the
tray. Insert 4 bolts and tighten securely.
If the optional Swing-Away Tray was ordered skip
to step 32.
Page 10
Adjustment Wheel
