7 . Place black cap onto the unit to cover
hardware.
Repeat these steps for installation of the second
rear caster.
8 . With assistance, place the base unit as shown,
if the back option was NOT ordered, skip to step
#21. Place the back as shown and place the
following arm as shown.
Place the controller and hand pendent on the
right hand side of the unit keeping the cables
clear of the following arm as shown below.
9A . Remove the screw from the following arm
and set the screw aside. You will need this later.
9B . On the following arm, turn the knob all the
way loose, flip the gray tab of the knob fully open
until it clicks open.
Following Arm
9A
9B
Page 3
34 . There are 2 knobs in the parts bag.
Screw each knob slightly into the tray bracket on
the unit. Place tray onto unit. Tighten securely.
Caution: After placing the tray into position,
ensure the ratchet handles on the side of the
tray are tightened securely.
35A . If the High Mount Chest Vest Bracket was
ordered, loosen knob on the bracket and insert
head support.
35B . If the Head Support was ordered, loosen the
knob on the back and insert the Head Support,
tighten knob securely.
36A . Insert each knee bracket assembly into
the tube along the seat post. Depress the spring
button to allow the bracket to slide into place,
advance until the spring button locks into place.
Tighten knob securely. For Swing-Away knees,
place into the tube, and tighten knob securely.
36B . Insert knee pad bracket into knee assembly,
Depress the spring button to allow the bracket to
slide into place, advance until the spring button
locks into place. Tighten knob securely.
Repeat steps for the other knee pad assembly.
Page 12
35A
35B
36A
36B
