EasyStand Bantam, Owner'S Manual

Seat Depth/Back Angle/Back Height

Caution: Do not adjust the seat depth while the child 

is in the unit

.

Caution: Ensure the colors on the seat tube and 

following arm match.

First remove the Shadow Tray and bring the seat up to 

a slight angle.

33 . Loosen the knobs on the seat tube and the follow-

ing arm. Do not unscrew knobs out all the way when 

adjusting the seat.
The Bantam Extra Small back angle adjustments are 

located above the locking knob. The back angle adjust-

ments go from green (largest) to blue (smallest).
The Bantam Small back angle adjustments are located 

below the locking knob. The back angle adjustments 

go from blue (smallest) to green (largest).
34 . Adjusting to a shorter setting: Adjust the fol-

lowing arm (back angle) first by depressing the spring 

button and moving no more than two holes at a time. 

Then adjust the seat tube (seat depth) one hole at a 

time. Continue this sequence until you achieve the 

desired setting and the colors on the seat tube and fol-

lowing arm match. 
Adjusting to a longer setting: Adjust the seat tube 

(seat depth) first by depressing the spring button and 

moving only one hole at a time. Then adjust the follow-

ing arm (back angle) no more than two holes at a time. 

Continue this sequence until you achieve the desired 

setting and the colors on the seat tube and 

following arm match. 
Note: For easier adjustment you may need to lift 

slightly as the seat depth adjustment is made.
Tighten the seat depth and following arm knobs 

securely when you have achieved the desired position.

!

!

Chest Vest Top Mounting Hole

Headrest Mounting Holes 

Chest Vest Top

Mounting Hole

Chest Vest Bottom 

Mounting Hole

Chest Vest 

Bottom Mounting 

Hole

Lateral Support Slot

Lateral Support 

Slot

Hip Supports/Lateral Supports Options

36 . The optional hip supports can be removed for 

transferring. The hip support width can be adjusted by 

loosening the knobs underneath the seat. Loosen the knob on 

the side of the unit to adjust the hip support width. Always 

tighten securely.

The hip supports have a number of attachment holes on the 

back of the pad allowing for additional positions vertically and 

horizontally. The pads can also be bolted on at a straight, 90º, 

180º, or 270º position.

37 . The optional lateral supports can be removed for 

transferring. The lateral support width can be adjusted by 

loosening the knobs on the back of the unit. Always tighten 

securely.

The lateral supports have a number of attachment holes on the 

back of the pad allowing for additional positions vertically and 

horizontally.  The pads can also be bolted on at a straight, 90º, 

180º, or 270º position.

Please check for fit and interference by bringing the unit to the 

maximum standing position and back to sitting again (without 

a user seated in the unit) as the pads may not work perfectly in 

all positions.
 

Accessories Mounting Bracket

38 . The accessories mounting bracket is attached to the back 

of the unit and is used for a wide range of options. The holes 

in the middle can be used for many styles of aftermarket head 

supports. There are holes for the chest vests, chest straps, and 

lateral supports. This bracket is standard on all units.

Attaching the Chest Vest

39 . Insert chest vest clips into slots as shown with tab 

facing up.

40 . Once the tab is past the bracket, pull back until snug.

36

Lateral Supports

Hip Supports

37

39

40

Page 15

Page 16

33

34

34