Perfect Fit Guide
page 35
page 4
Perfect Fit Guide
step one - measure
Before transferring into the Evolv, measure for
approximate (A) seat depth and seat to (B) foot
plate settings.
step two - seat depth
Use the above measurement (A) to adjust the seat
depth on the stander, measure from the front of
the seat to the back. To adjust the seat depth,
loosen the knob under the seat (C). Depress the
snap button on the adjustment tube while moving
the back (D). Adjust the seat depth until the proper
measurement has been reached. Tighten the knob
(C) after adjusting.
step three - back angle
After achieving the desired seat depth, rotate the
back angle (E) adjustment knob so the (F) seat/
back angle indicator is in the green area prior to
standing.
Note: Repeat steps 2 and 3 for each color adjust-
ment.
step four - foot plates
Use the (B) measurement to adjust the foot plate
height. Loosen the (G) ratchet handles on the foot
plates to adjust height and lantar/dorsi. Tighten
ratchet handles after positioning. The knees should
be slightly lower than the hip (H).
step five - positioning
Position the user’s hips as close as possible to (I)
Evolv’s hip pivot. To determine correct positioning,
only two fingers should fit between the front of the
seat and the back of the knee (J).
step six - knee pad
Adjust the (K) knee pad so it fits comfortably up to
the knees.
(C)
(D)
(B)
(A)
(F)
(E)
Inspect your standing frame periodically to ensure it is
in safe operating condition.
Caution: These adjustments are only to be made
while the unit is unoccupied and in the seated
position.
!
(G)
(H)
(K)
(I)
(J)
