EasyStand StrapStand, Assembly Manual

FIG . 6- Remove all hardware from the knee bracket. Make 

sure the 2 nuts are in the back side of the clamp, place the 

clamp into the knee slot on the unit. Place the knee 

bracket and the spacer into the slot making sure the 

spacer is between the knee bracket and knee slot, lining up 

with the clamp.

Note the curve of the knee bracket is up. 

FIG . 7- Place washer onto the ratchet handle insert handle 

through the knee bracket, spacer and into the clamp. 

Place washer onto the bolt, insert bolt through the knee 

bracket, spacer and into the clamp. Tighten snug, but allow 

knee assembly to slide freely.

FIG . 8- For standard knee pads, remove the three bolts from 

the knee pad, making sure the plastic insert stays in place. 

Place the knee pad onto the bracket and insert top two bolts 

before inserting the middle bolt. Tighten 

securely. 

For independent knee pads, place the knee pads onto the 

knee pad brackets, tighten knobs securely. The narrow end 

of the slotted washer for the knee pads will be inserted into 

the bracket.

REFERENCE DRAWING ON P . 11 . 

FIG. 6

FIG. 8

Spacer

Clamp

FIG. 7

FIG.8

Knee Pad

Plastic Insert

Slotted Washers

Knee Slot

4

Standard 

Knee Pads

Independent 

Knee Pads