45. If the lateral supports were ordered,
loosen knob on the lateral support clamp
behind the upper body support pad. Insert
lateral supports and tighten knob securely.
Repeat steps for other lateral support.
45
Page 17
Charging the Battery
The EasyStand Zing Pow’r Up Lift uses two 12-volt sealed lead batteries rated at 2.9 amps each. An
EasyStand Zing can be lifted approximately 100 times on one full battery charge. An audible alarm will
sound when the battery is low. Please charge the battery after the alarm sounds. A battery needing to
be fully recharged will take approximately 8 hours. The EasyStand Zing Pow’r Up Lift can be used while
being charged. The function of the charger is to detect a full battery and then provide a constant
potential power supply to hold the battery at a full condition without
overcharging. When the battery EMF rises to a factory preset point, the
charger circuit will not allow the peak output voltage to exceed that value.
This factory setting protects a battery from excessive depletion of
electrolyte, which can occur from overcharging. The charger can be found
in the tool pouch on the back of the unit.
CAUTION: Use only the Linak charger, model number 10CH01S-00,
provided by Altimate Medical with the Pow’r Up option.
1. Plug the receptacle into a wall outlet. The length of the charger cable
is 80" (203cm). The light on the charger will be green indicating an open
circuit.
2. FIG . A- Plug the charger cord into the side of the hand control. The light
on the charger will turn yellow indicating the batteries are being charged.
The length of the hand pendant cable is 30" (76cm), retracted.
3. FIG . B- The unit will arrive unplugged from the battery, plug in the white
cord that supplies power to the actuator and the black cord that supplies
power to the remote. The black cord has a notch on it to orient the
connector properly. Fully charge battery before use.
Note: The white cord has a rubber washer on it, which makes it very sticky
and sometimes will not get pushed in completely, make sure to push the
cord all the way into the battery.
4. When the batteries are charged, the light on the charger will turn green.
5. Fully charge the batteries every three months or less during periods of
intermittent or non-use.
CAUTION: The Zing Pow’r Up Option is not designed for
continuous use. Duty Cycle 5% Max, 1 min. / 19 min.
Raising the Lift - Press the UP (arrow up) button on the hand control to lift
the Zing.
Lowering the Lift - Press the DOWN (arrow down) button on the hand control to lower the Zing.
CAUTION: Ensure the cables are attached properly per the instructions for use. Do not allow the cables
to drag on the floor or to catch on objects.
Pow’r Up Lift Option Usage
FIG . A
FIG . B
!
!
!
The hand pendant is a
Type BF applied part.
43. If the Prone model was ordered. Loosen
ratchet handles on the side of the tray. Flip
tray support brackets up as shown. Tighten
ratchet handles securely.
44. Insert tray support brackets into the
following tubes as shown. Depress spring
button and place tray into desired position,
tighten knobs securely.
44
43
Prone
Prone
Elbow Stop/Arm Rest
Lateral Supports
Prone Lateral Supports
Page 22
