0
6
“EasySteam” company's furnaces are made from stainless heat-resistant steel with chrome
content not less than 17% and wall thickness more than 4 mm. The furnace body (point 1) is a complex
bent-welded structure with additional elements to reinforce the construction. There are convection
canals (point 2) on the outside of side-walls. Maintaining the flame temperature high inside the
furnace is essential for the heating up of the heater's filling (point 3) to the uttermost. There are
protective heat-retaining shields (point 4) inside the furnace which help to redistribute the tempera-
ture load inside the furnace, significantly increase the heat energy transfer to the bottom of the
heater and to take the load o the load-bearing wall.
The heater is a complex reservoir in the center of the furnace.
In order to fully and evenly heat up the heater's filling and to be able to regulate the heating
process, there is a main chimney (point 6) in the heater in addition to manufacturing clearances
between the heater and the furnace body. The flame spreader (point 5) is installed in the furnace to
prevent the penetration of high-temperature flame in the chimney flue through the main chimney.
When the flame spreader is working the most flames are staying in the furnace heating it up and only
combustion gases end up in the chimney.
In order to equally distribute the load of massive heater's filling, the heater's bottom is made
semicircular that also let's to increase the heating area and to prevent the bottom elevated-
temperature deformation. Maintenance of the equipment is done through the steam pipe (point
7).
вых нагрузках.
Due to the fact that in the operating process the heater is one of the most loaded elements, total
mass of the filling shouldn't exceed the maximum value mentioned in this manual!
Steam generating unit (point 8), which is a complex system of vertical and horizontal pipes,
is installed in the heater to get high quality finely dispersed steam. Pin-holes are made in horizontal
pipes to ensure even distribution of steam-water mixture over the most heated-up bottom layer of
the heater's filling. The dispensing unit is attached to the upper part of the steam generating unit.
There is a safety (back pressure) valve in order to prevent an unpermitted emission of steam-water
mixture in the opposite direction.
Before usage, it is necessary to check the performance capability of the dispensing unit. Remove
(screw o ) the dispensing unit and examine the safety valve. In case of discovering of foreign
object (small pieces of bath besom or so on), remove them and wash the device properly.