QUICK START GUIDE
８
|
P a g e
Remark
Directory
9. Data cable
10. Small wrench and
tweezers
11.Filament blanket
12
、
Instruction manual
Quantity
1 pcs
1 set
1 pcs
1 pcs
Remark
7
FAQ
Q1: Why is the printing model not adhesive to the platform?
A1: The nozzle is too far away from the platform, Adjust the distance between them to assure that the distance is just
enough to get through a calibrated film.
Q2: Why the filament do not come out from the nozzle?
A1: Check the filament feeder, heating and feeding filament, if there is external gear structure feeder, then to observe if
gear rotates or not, if there is built-in stepper motor feeder, then to observe if the motor is vibrating and working sound or
not, if no. Then check if the wire of filament feeder and motherboard is completed or not. Please repair timely if its
in-completed.
A2, Check temperature.
Printing nozzle temperature of PLA material range s from 195
℃
-210
℃
.
A3, Check if the nozzle is blocked.
If PLA filament is already heated to then use force to push the filament, if it does not come out, then disassemble the
nozzle and clean it or replace the nozzle.
A4, Check if nozzle is too close to the platform, if yes, then filament can not come out, so adjust the distance between
platform and nozzle to assure it can just enough to get through a calibrated film.
Q3, The problem of print model misplaced
A1, Mistake of slicing, re-slice, Or the software to reproduce GCode printing.
A2,The model drawings problem. If the model still misplaced after re-slicing the models, then its drawing has problem.
A3, the nozzle is forced to stop printing Path:
First, You can not touch the moving nozzle with your hands during the printing process. S
A4, motherboard problem:
If the above problems can not solve the dislocation, and if all dislocation happens at the same height of any model then
replace the motherboard. There is big gap between actual and theory printing accuracy
