Inserting and changing the batteries
Your easytip S7 is powered by two (alkaline) 1.5 V batteries (IEC LR 03, AAA)
Insert the batteries following the markings in the battery compartment.
After inserting the batteries, your easytip S7 is adjusted for TV-operation.
If the LED does not blink as usual when pressing the keys or if the device you are controlling
fails to respond from the usual distance then the batteries must be changed.
Your easytip S7 includes a intermediate memory which prevents the easytip S7 from losing its
memory during the battery changing.
Please dispose batteries carefully.
Programming easytip S7
Programming by Code entering
1. Switch on the device you want to use your easytip S7 with.
2. Turn to the TV code list (other manual) and look for the name of your device manufacturer.
3.
TV, VCR, SAT
Choose the device you want to adjust by pressing the Level key and keep it pressed (for
about 5 seconds) until the LED blinks twice. Continue with step 4.
CD, TAPE, TUNER
Press the Preselection key to get to the AUDIO-mode. Then choose the device you want
to adjust by pressing the Level key and keep it pressed (for about 5 seconds) until the
LED blinks twice. Continue with step 4.
AMPLIFIER
Press the Preselection key to get to the AUDIO-mode. Then choose the device you want
to adjust by pressing the Level key and keep it pressed (for about 5 seconds) until the
LED blinks twice. Then press the Preselection key “TUNER” briefly to get to the AMPLI-
FIER-mode. Continue with step 4.
4. Enter the first 3-digit code from the list with the number keys on your remote control.
ATTENTION!
The first figure of the 3-digit cod must be entered within 5 seconds of the LED blinking twice.
Otherwise the LED will flash once and you will have to repeat the procedure from step 3.
After the 3-digit code has been entered the LED will blink twice to indicate that the code has
been accepted.
ATTENTION!
If you entered the first digit within 5 seconds but still see one long flash from the LED after
you have entered the code, this means the code you entered is invalid.
In this case, repeat the procedure from step 3.
Now point your easytip S7 at your device and try to operate your device with your easytip
S7.
If your device does not react to the device code number you entered or if it operates incor-
rectly, enter the next number listed against the device manufacturerís name.
The code list shows the most common codes first.
If none of the code numbers listed in the code list work properly use the Code search
function.
Make a note of your 3-digit code numbers.
NOTE:
By entering code 000 you can restore the basic settings of your easytip S7. You can
then program easytip S7 newly.
Code Search
If none of the codes listed for your device work or if a previously entered code number no
longer works or works unsatisfactorily, use the code search.
1. Switch on chosen device.
2.
TV, VCR, SAT
Choose the device you want to adjust by using the Level key and press the key (for about
3
TV
VCR
SAT
CD
TAPE
TUNER
AMPLIFIER
