PAGE - 9 -
PAGE - 8 -
2.2.3 R.O. installation for building and apartment
On the outlet of water tower supposed to have individual
water supply tube please try to find your tube number
(As
shown in Figure 8) and turn it off. Some European style
faucets have turn off device.
★
Notice: Basically, there are two type of faucet which are
single and dual. The machine is equipped with
single faucet only. If your faucet is dual style,
please purchase another installation package-
please be aware of dimension.
2-3 Installation
2.3.1 Make sure the inlet of water source had turned off.
2.3.2 Please wind the Teflon tape around the outside
thread of inlet adaptor and then connect the ball
valve to water inlet adaptor. This is common water
inlet adaptor set.
(As shown in Figure 9)
2.3.3 Please wind the tape around the outside thread of
water inlet adaptor and then screw it down to the
connect point of faucet. After that, connect it with
faucet.
2.3.4 Drill-You must drill three holes in order to install the
power source, water source and gooseneck faucet.
If you install the machine on counter, there is no
need to drill hole2 and hole3. If your water and
power and power source are under counter, there is
no need for two holes. Before drilling, please make
sure no pillar under the counter. Due to length of
faucet, it will not be able to install.
Hole 1. Hole for installation of gooseneck faucet, please
select a position for the installation of gooseneck faucet.
Figure 14.
Figure 10.
Conventional faucet
Figure 11.
Figure 13.
Figure 12.
Hole2.Hole of water inlet.provide power source
through counter. If the power source is under counter,
there is no need to drill a hole.
Hole 3. Hole for entrance of power supply into counter.
If the counter already has power supply device, there
is not necessary to drill a hole on the counter.
Confirmation of hole dimension.
Confirmed hole dimension-hole1 13m/m or 1/2''
Confirmed hole dimension-hole2 6.5m/m or1/4''
Confirmed hole dimension-hole3 6.5m/m or1/4''
2.3.5 Installation of goosensck faucet: Pease refer to
the picture and lock it with hole1 on the counter.
After installation, make sure the object will not
loosen.
2.3.6 Water distribution: Select untreated water
position, it can be recycled and flush toilet or
other purpose. Also, the untreated water can go
through water pipe directly.
2.3.7 Storage tank - Install the ball valve on the top of tank.
Aim the outlet of ball valve at the hole of storage
tank. Put the storage tank under the counter or the
place you require to place. Press the switch of ball
valve.
Figure 15.
plastic washer
hex fixing nut
1/4" hex nuts
1/4" pipe plug
Upper copper washer
upper rubber spacer
gooseneck faucet
bracket
lower rubber spacer
fixing perforate nut
Figure 16. Gooseneck
faucet assembly diagram
