APP4V1043T-EC10T
•
Don’t hook up the ¼’’ copper tubing on the top of the cylinder heads unless using a pilot valve.
•
Make sure there is a tube from the check valve in the tank to the unloader on the pressure switch.
This will relieve the head pressure when the compressor stops. This will make it easier for the
motor when the compressor goes to restart.
•
Fill crankcase with Airbase Industries synthetic piston air compressor oil, to the center of the sight
glass. (Genuine Airbase synthetic compressor oil is required to maintain your warranty from Eaton
and can be purchased over our web site.)
•
Size the correct pulley for your motor. When using a 7.5 HP motor use a 3 1/2’’ pulley on a 3450
rpm motor and a 7’’ pulley on a 1750 rpm motor. When using a 10 HP motor that runs 3450 rpm
use a 4 ½’’ pulley and a 9’’ pulley when using a 1750 rpm motor.
•
Install your belts. There should be a ½’’ of play on the belt tension.
•
Turn on the motor and check for proper rotation. The pump
must
run counter clockwise when
facing the pulley side of the compressor.
3
Summary of Contents for POLAR AIR PP05H080I1
Page 1: ...Polar Air Electric Operated Piston Compressors 1...
Page 32: ......
Page 38: ...APP4V1043T EC10T...
