Polar Compressor Rotary Screw Compressors
Revision July.2015
www.eatoncompressor .com
877.283.7614
14 |
P a g e
5.
WP1 (Top Range Transducer pressure)
shows in the display. Press Enter and the
pressure setting flashes and can be
changed by using the Up & Down
Arrows. Press Enter again to confirm
the setting.
6.
Press down Arrow to see and/or
change the other pressure settings.
Once satisfied with all settings, press
Down Arrow until you are back to
the Main Screen.
Clock Timer Settings
This feature allows the operator to set the
start and stop times (in 24 hour time) of the
compressor, every day of the week.
Up to 3 time slots can be programmed per
day. Example:
Day 1 (Monday)
1 – ON 07:30 – OFF 12:30
2 – ON 13:30 – OFF 17:30
3 – ON 18:30 – OFF 23:30
Once Day 1 is set, Day 2 through Day 7 can
be programmed. (See page 17 of the PLC
manual for more details.)
Working Timer - Unloading Delay
To reduce wear & tear of the compressor
components, an unloading delay time is set
in the controls that shuts-down the
compressor after the unloading delay time
has counted down.
If the compressor is running in slow periods
of the day, the compressor could run for
long periods in the unloading stage, causing
unnecessary component wear and elevated
energy costs.
With an unload delay time of 10 minutes,
for example, the compressor would run for
10 minutes in the unloading stage and then it
would shut down and enter a stand-by mode.
Then when the low pressure setting is
reached, the compressor automatically starts
again.
1.
To view or set the unload delay time,
start with the main screen shown
below.
2.
Press the two arrow keys at the same
time to bring up the Password Level
Selection- Press down arrow 2 times
to select Level 3 then press enter.
Use to navigate through
settings.
The Enter button used
to navigate through
settings.
