OPERATION
EATON
Powerware
®
9135 Two−in−One UPS (5000/6000 VA) User’s Guide
S
164201726 Rev 1
www.powerware.com
48
Turning the UPS On
To turn the UPS on:
1.
Verify that the UPS internal battery connector is connected (see
Figure 2 on page 22).
2.
Set the upstream circuit breaker (not included) to the ON position.
The equipment is powered by utility power, but not protected by
the UPS.
Batteries are recharging. An eight−hour recharge period is necessary
to get full backup time.
The
and
indicators illuminate.
To change the factory-set defaults, see User Settings " on
page 52.
3.
Press and hold the
button until you hear the UPS beep
(approximately three seconds).
After the UPS is turned on, it conducts a self−test and enters
Normal mode. The
indicator remains on and the
indicator
turns off indicating that power is available to your equipment.
If the alarm beeps or a UPS alarm indicator stays on, see
Troubleshooting" on page 67.
Starting the UPS on Battery
NOTE
Before using this feature, the UPS ON/OFF settings must have been enabled (see
Table 5 on page 53).
To turn on the UPS without using utility power, press and hold the
button for three seconds. The UPS starts up in Battery mode and
supplies battery power to your equipment.
