Figure 21. Industrial Relay Card INDRELAY-MS
5.5.5
MiniSlot interface connections
For MiniSlot accessories and communication devices selection, see Chapter
.
For installation and setup of a MiniSlot card, please contact your Eaton
representative.
To install wiring to the connections:
1.
If not already installed, install the LAN drops.
2.
Open the front door of the UPS.
3.
To remove the MiniSlot cover plate, remove the 2 screws securing the
plate.
4.
To install the MiniSlot communication device, push it all the way in.
5.
Secure the MiniSlot communication device with 2 screws.
6.
Route and install the LAN and other cables to the appropriate MiniSlot
cards. The cable route is through the signal cable canal in the top section
of the UPS.
7.
For operator instructions, refer to the manual supplied with the MiniSlot
card.
8.
When all the wiring is completed, close the front door and secure it with the
latch.
5.5.6
Installing signal interface connections in a parallel system
The installation of the signal interface connections in a parallel system is done
by following the aforementioned instructors. The signal polarity must be taken
into account when putting signal inputs and EPO wiring in parallel. Signal inputs
Eaton 91PS/93PS UPS 8–40 kW
User's and installation guide
©
Eaton Corporation plc 2018. All rights reserved.
Revision: 005
Document ID: P-164000493
63 (117)
