Eaton
®
9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual
S
164201603 Rev 4
www.eaton.com/powerquality
12-1
Chapter 12
Communication
This chapter describes the communication features of the Eaton 9390 20–80 kVA
UPS and provides information about connecting hardware and using Terminal mode.
12.1
X-Slot Cards
The Eaton 9390 UPS has two standard, factory‐installed X-Slot communication bays
with two slots each. See Drawing 164201603-10 starting on page A-46 for bay
locations. The UPS is compatible with the following X-Slot cards (see Figure 12‐1):
S
Power Xpert Gateway Card – provides a data gateway from the UPS to the Power
Xpert Software; provides remote monitoring through a Web browser interface,
e-mail, and a network managment system using SNMP; connects to a twisted-pair
Ethernet (10/100BaseT) network. Modbus TCP support provides direct integration
of the UPS's parameters to a Building Management System (BMS). It has a built-in
switching hub that allows a second network device to be connected to the
network without the requirement of an additional network drop.
S
ConnectUPS-MX SNMP Card – has SNMP and HTTP capabilities as well as
monitoring through a Web browser interface; connects to a twisted-pair Ethernet
(10/100BaseT) network. It has a built-in switching hub that allows three additional
network devices to be connected to the network without the requirement of
additional network drops. In addition, a Powerware Environmental Monitoring
Probe (EMP) can be attached to obtain humidity, temperature, smoke alarm, and
security information.
S
Powerware Hot Sync CAN Bridge Card – provides connectivity for operational
mode control and metering of a parallel system at any UPM in the system. In
addition, this card can be used to connect optional system monitoring devices,
such as a Remote Monitor Panel II (RMP II), a Relay Interface Module II (RIM II), or
a Supervisory Contact Module II (SCM II) to the UPS.
S
Industrial Relay Card IRC – indicates the operating status of the UPS system using
the customer's monitoring equipment. The IRC uses four isolated normally-open or
normally-closed dry relay contacts to indicate the UPS status. Normal, Bypass,
Battery, and Alarm modes can be monitored.
S
Relay Interface Card AS/400 – has isolated dry contact (Form-C) relay outputs for
UPS status: Utility failure, Low battery, UPS alarm/OK, or On bypass when
interfacing with IBM
®
AS/400 computers, other relay connected computers, and
industrial applications.
S
Modbus
®
Card – provides direct integration of UPS information (meters and status)
to a BMS using the Modbus RTU protocol.
NOTE
The Modem Card cannot be installed in X-Slot 2.
S
Modem Card – provides out-of-band remote notification and monitoring using
modem communication directly to cell phones and pagers.
LAN and telephone drops for use with X-Slot cards must be provided by facility
planners or the customer.
For installation and setup of an X-Slot card, please contact Eaton (see page 1-8). Refer
to the manual supplied with the X-Slot card for user instructions.
Figure
Summary of Contents for 9390IT
Page 2: ......
Page 6: ...This page intentionally left blank...
Page 237: ......
Page 238: ...1642016034 164201603 4...
