INSTALLING THE UPS SYSTEM
Eaton
®
9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual
S
164201603 Rev 4
www.eaton.com/powerquality
4-5
10.
If installing the cabinet permanently, retain the shipping brackets and hardware;
otherwise, discard or recycle the pallet and rear bracket in a responsible manner.
11.
If permanently mounting the system, proceed to Step 15; otherwise, continue to
Step 12.
W
A
R
N
I
N
G
The front anti-tip/shipping bracket must be reinstalled; otherwise, injury and damage to the UPS may result
when removing components during service. If the bracket is not reinstalled, the cabinet may tip and cause
serious injury and damage.
12.
Secure the UPS cabinet in position by lowering the leveling feet until the cabinet
is not resting on the casters and the cabinet is level.
13.
Using the retained hardware, reinstall the front anti-tip/shipping bracket (bracket
with wider base) removed in Step 3 to the front of UPS cabinet with the angle
facing outward and adjusted level with the floor (see Figure 4‐1).
14.
If installing battery and distribution cabinets, proceed to paragraphs 4.3 and 4.4;
otherwise, proceed to paragraph 4.7.
15.
Using the retained hardware, reinstall the shipping brackets removed in Step 5 to
the front and rear of the UPS cabinet with the angle facing outward (see
Figure 4‐1 and Figure 4‐2).
16.
Secure the cabinet to the floor with customer-supplied hardware.
17.
If installing battery and distribution cabinets, proceed to paragraphs 4.3 and 4.4;
otherwise, proceed to paragraph 4.7.
4.2.2
Unloading the 9390IT Cabinet
The UPS cabinet is bolted to a wooden pallet supported by wood skids. To remove
the cabinet from the pallet:
1.
If not already moved, use a forklift or pallet jack to move the cabinet to the
installation area, or as close as possible, before unloading from the pallet. Insert
the forklift jacks between the skids.
W
A
R
N
I
N
G
The UPS cabinet is heavy. See Table B on page A-4 for weight of cabinets. If unloading instructions are not
closely followed, the cabinet may cause serious injury.
C
A
U
T
I
O
N
Do not tilt cabinets more than 10° sideways from vertical.
NOTE
Verify that the forklift or pallet jack is rated to handle the weight of the cabinet (see Table B on
2.
Unfasten the front door latch and swing the door open (see Figure 4‐3).
NOTE
The cabinet is front and top heavy. Do not remove the front shipping skid until all other brackets have
been removed to prevent the unit from tipping forward during the other procedures.
Summary of Contents for 9390IT
Page 2: ......
Page 6: ...This page intentionally left blank...
Page 237: ......
Page 238: ...1642016034 164201603 4...
