Installation
4-2
Eaton 93E Integrated Transformer Cabinet (ITC) Installation Manual P-164000074—Rev 3
www.eaton.com/powerquality
Figure 4-1. Removing the Front Shipping Bracket – 93E 30ITC
5.
Remove four bolts securing the rear shipping bracket to the cabinet and four bolts securing the bracket to
the pallet (see Figure 4-2). Remove the rear shipping bracket. If installing the cabinet permanently, retain
the shipping bracket and securing hardware for later use.
6.
Close the door and secure the latch before rolling the cabinet from the pallet.
7.
Remove three bolts securing the removable skid (see Figure 4-2).
8.
Remove two bolts securing the pallet extension plate to the pallet and remove the plate (see Figure 4-1).
9.
Install the pallet extension plate onto the rear of the pallet using the retained bolts (see Figure 4-3). Use
the mounting holes provided in the pallet (see Figure 4-2).
10. Use a forklift or pallet jack between the supports on the bottom of the pallet to lift the pallet by
approximately 3 mm (1/8") and remove the skid (see Figure 4-2).
Front Door
Shipping Bracket Bolts
Shipping Bracket Bolts
Front Shipping Bracket
Pallet
Pallet Extension Plate
(installed for shipping)
NOTE 1
In Step 11 the pallet tilts and acts as a ramp when the cabinet is rolled beyond the
center of the pallet.
NOTE 2
The pallet extension may bend when the pallet is tilted, but will continue to provide
a smooth transition to the floor.
