Installation
4-8
Eaton 93E Integrated Transformer Cabinet (ITC) Installation Manual P-164000074—Rev 3
www.eaton.com/powerquality
4.3
Installing the Power Terminal Cover Base
To install the power terminal cover base:
1.
Locate the terminal cover base (see Figure 4-5) from the parts kit.
2.
If installing wiring using conduit, continue to Step 3; otherwise, skip to Step 4.
3.
Punch or drill holes in the bottom of the power terminal cover base (see Figure 4-5 and Figure 4-6) for the
transformer AC input and output conduits.
4.
Using the hardware provided, install the terminal cover base to the back panel of the ITC using the existing
cabinet screw holes (see Figure 4-6).
5.
Continue to paragraph 4.4.
Figure 4-5. ITC Power Terminal Cover Parts
NOTE
Wiring can be installed using conduit between cabinets or by routing wiring through
the power terminal cover base wiring channels.
Top
Left Side
Conduit Landing for
Transformer Input and
Output when using conduit
(Install conduit to bottom
of base.)
Right Side
Base
Wire Hooks
Base (inside view)
NOTE
Do not install the Power Terminal Cover Left and/or Right Side covers if wiring adjacent cabinets using the
power terminal base wiring channel.
