Eaton 93E UPS 15-80 kVA (380/400/415 V)
Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved.
Revision: 001
Document ID: 614-01975-00
93 (133)
Function
Sub-function
Operation
Setup – User
Function
Selection
This screen can be used to display user
information and show the installed firmware
versions. Use the
or
push buttons to
select the SETUP symbol on the main menu
bar to display the Setup screen. Use the
or push button to highlight the desired
function, then press the
push button to
display the function screen. See Figure 41
for a typical screen display.
User Info
The User Info screen provides the model,
CTO and serial numbers of the UPS, the
output voltage, frequency, and kVA rating,
the input voltage rating, and the battery run
time rating. Use the
or
push buttons
to select USER on the Setup menu bar. Use
the or push button to select Info, then
press the
push button to display the
function screen. To return to the System
Setup screen, press the ESC push button.
About
The About screen provides the installed
firmware version numbers on the UPS. Use
the
or
push buttons to select USER
on the Setup menu bar. Use the or
push button to select About. To return to the
System Setup screen, press the ESC push
button.
Setup –
Config
(System
Level 1
Setup)
Password
To enter a password if required, use the
or
push button to select the password
character position. Use the or push
button to change the password character.
Once the password is entered, select DONE
and then press the
push button. The
System Setup Level 1 menu screen is
displayed. The default System Setup Level 1
password is 0101.
