P-164000427
SMALL and LARGE BATTERY CABINET
8
Revision 2
User's and Installation Guide
Figure 2 -2: 93P/E battery cabinet (Large Battery Cabinet)
A DC-rated circuit breaker within each cabinet provides protection and service isolation.
The battery cabinets use convection cooling to regulate internal component temperature. Air inlets are at
the bottom and in Large Battery Cabinet also in the front of the cabinet and outlets are on the rear of the
cabinet. Clearance must be allowed in front and rear of each cabinet for proper air circulation.
The system must be installed on a level floor suitable for computer or electronic equipment.
The system must be installed in a temperature and humidity controlled indoor area free of
conductive contaminants.
2.1 Preparing the Small Battery Cabinet installation
NOTE
The battery cabinet is heavy. If unpacking instructions are not closely followed, the
cabinet may tip and cause serious injury.
1.
If not already accomplished, use a forklift or other material handling equipment to
move the cabinet to the installation area, or as close as possible, before unloading
from the pallet. Insert the forklift jacks between the skids on the bottom of the unit.
2.
Open the package, remove the front and rear mounting brackets, and attach the
ramp to a front edge of the pallet.
Summary of Contents for 93P
Page 2: ...Eaton 93P ESMALLandLARGEEXTERNALBATTERYCABINET P 164000427 User s and Installation Guide...
Page 3: ......
Page 4: ...Eaton 93P E SMALL and LARGE External Battery Cabinet User s and Installation Guide...
Page 27: ...P 164000427 SMALL and LARGE BATTERY CABINET 21 Revision 2 User s and Installation Guide...
