Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass (50 kW and 100 kW SIAC-B) Installation and Operation Manual P-164000230—Rev 09
35
4.
Loosen, but do not remove, the skid mounting bolts holding the pallet skids to the front and rear supports,
and to the left and right side supports.
RISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become unbalanced. To
prevent tipping the cabinet, raise the cabinet no more than 3 mm (1/8") above the floor (just enough to allow the
removal of the pallet skids). Failure to follow these instructions can result in serious injury or death.
5.
Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately
3 mm (1/8").
6.
Remove the hardware loosened in
Step 4
.
7.
Pull the pallet skids out from under the metal angle supports without disturbing the jacking bolts. Recycle
the pallet skids and hardware in a responsible manner.
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base. The cabinet
must be lowered by the jacking bolts before the supports can be removed.
8.
Carefully and evenly
lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum)
until the cabinet side wheels contact the floor and the cabinet is no longer supported by the
jacking bolts.
9.
After the SIAC-B is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
10. Remove the shipping brace screws securing the front left and right shipping braces to the cabinet. Do not
reinstall screws. Recycle the screws in a responsible manner.
11. Remove the bolts securing the front left and right shipping braces to the front cabinet support. Remove
the braces.
12. Remove the screws securing the back left and right shipping braces to the cabinet. Reinstall the screws
(without the nylon washers) to secure the rear panel to the frame.
13. Remove the bolts securing the back left and right shipping braces to the rear cabinet support. Remove the
braces.
14. Remove the cabinet support bolts fastening the front, rear, and side cabinet supports together and remove
the side supports.
15. Remove the cabinet mounting bolts holding the front and rear supports to the cabinet base.
16. Recycle the bolts along with the shipping braces and support brackets in a responsible manner.
17. Reinstall the SIAC-B front panel and secure with retained screw.
18. If the leveling feet are not retracted, turn all four leveling feet until they are retracted as far into the cabinet
as possible.
To prevent tipping when rolling the cabinet and damage to the front door, push the cabinet from the rear
whenever possible. Do not push the cabinet from the sides.
19. Roll the cabinet close to the final installation location.
Summary of Contents for 93PM IBC-L
Page 82: ...P 16400023009 P 164000230 09...
