34
Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass (50 kW and 100 kW SIAC-B) Installation and Operation Manual P-164000230—Rev 09
2.
Remove the screw securing the bottom of the SIAC-B front panel. Lift the panel straight up to remove it
from the panel hanger bracket at the top of the cabinet. Retain screw for later use.
3.
Locate the four 1/2" jacking bolts from the parts kit and install them in the threaded holes in the front and
rear supports as shown in
. Place a floor protector from the parts kit underneath each jacking bolt,
and screw the bolts down against them.
The floor protectors protect the floor from being marred by the jacking bolts.
Figure 12. Removing the Pallet Skids and Supports – Eaton 93PM Field Installed SIAC-B
Cabinet
Mounting Bolts
(2 places front)
(2 places rear)
Skid Mounting Bolts
(4 places front)
(4 places rear)
Floor Protectors
(2 places front)
Right Side
Cabinet Support
Jacking Bolts
(2 places front)
(2 places rear)
Front Cabinet
Support
Shipping Brace
(2 places front)
(2 places rear)
Shipping Brace
Mounting Bolts
(2 places front)
(2 places rear)
Shipping Brace
Mounting Screws
(2 places front)
(2 places rear)
Pallet Skid
Left Side
Cabinet Support
Rear Cabinet
Support
Cabinet
Support Bolts
(2 places at
each corner)
Cabinet Side Wheels
(2 places left side)
(2 places right side)
SIAC-B to UPS Cabinet
Side Tie Strap
Do not remove or loosen the cabinet mounting or cabinet support bolts until instructed. If unpacking and
unloading instructions are not closely followed, the cabinet may tip and cause serious injury or death.
Summary of Contents for 93PM IBC-L
Page 82: ...P 16400023009 P 164000230 09...