49
4. Operation
This section describes the operation of the MBP, using the operation of the 1+1 Parallel MBP
as an example.
4.1 Wiring of detection cable
Notes:
•
Refer to section 3 to complete the AC connection of the UPS and MBP.
•
Refer to the UPS user manual or EBM quick start guide to complete the EBM
connection
•
Refer to the UPS user manual for the connection of the ‘parallel cable’ between
multiple UPS
Set up the system’s detection loop following the steps below:
1.
MBP detection: connect the MBP to UPS1 via the
‘MBP Detection cable’, included
with the MBP
2.
EBM 1 detection: connect EBM 1 of UPS 1 to the MBP via the
‘EBM Detection
cable’, included in the EBM box
3.
EBM 2 detection: connect EBM 1 of UPS 2 to the MBP via the
‘EBM Detection
cable’, included in the EBM box
Note: If the paralleled UPS system is used for redundancy, the Neutral switch needs to be kept
at the ‘ON’ position when any of the UPS is removed.
Summary of Contents for 9SX 15K Series
