100
Dry out is relay output interface, which is normally open, can be used to indicate
the UPS load overload, battery mode, battery low voltage, battery not connected,
bypass output and other working conditions.
Reference 7.3.4 to setting Dry in & out details
Modbus/BMS port and DIP switch
Modbus/BMS port support Modbus or Lithium battery BMS communication.
The port defaults to Modbus communication function, which can provide
communication with a maximum of 5 UPS. When connecting hand-in-hand, you
need to use one-two terminal (please contact the service person for the terminal).
SW-2 in the DIP switch is the enable terminal resistance switch. The default is Off
(when it is used as the terminal device, it is recommended to turn ON).
When the Lithium battery BMS communication, the DIP switch SW-1 defaults to Off,
and needs to be turned ON when connecting the lithium battery pack.
Intelligent slot(support hot swap)
Smart slot can be installed with Genepi-IT communication card, Genepi-FA
Modbus card and Relay-MS dry contact card. If necessary, please contact your
supplier.
Summary of Contents for 9SX 15KPMAU Series
