Operation Overview
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
51
HTTP Control
Indicates if the Web interface is accessible.
Disabled: the Web interface is accessible.
Default is Enabled: the Web interface is not accessible.
SSL Control
Indicates if the SSL encryption is enabled for the Web interface.
Enabled: the Web interface is with SSL encryption (use https://IP_address).
Default is Disabled: the Web interface is without SSL encryption (use http://IP_address).
Multi-User Login
Multi-User Login.
Maximum 15 characters.
Multi-User Password
Multi-User Password
Maximum 15 characters.
Minimum 5 characters.
Multi-User Security Level
Indicates the rights allowed to the user as follows:
No access: the user cannot log into the Web interface,
Read-only: the user can access the Web interface but cannot make any changes,
Read/write: the user can access the Web interface and modify the settings.
SMTP Server
IPv4 or IPv6 or host name of the SMTP server to use to send e-mail.
SMTP Server Authentication Control
Indicates if the SMTP server requires authentication to connect to it.
Enabled: an authentication is required. The optional user-defined login and password are used to
authenticate.
Default is Disabled: no authentication is required.
Optional SMTP Server Login
Optional login parameter to authenticate on the SMTP server.
Maximum 31 characters.
Optional SMTP Server Password
Optional password parameter to authenticate on the SMTP server.
Maximum 31 characters.
Minimum 5 characters.
Sender Address
Address that appears as sender field of the e-mail sent by the ePDU.
Maximum 31 characters.
Default is ePDU@eaton.com.
Primary DNS server
IPv4 or IPv6 address of the primary DNS server.
Secondary DNS server
IPv4 or IPv6 address of the secondary DNS server.
SNMP version
Indicates the version of the operating SNMP agent.
SNMPv1: the SNMP agent only supports SNMPv1,
SNMPv3: the SNMP agent only supports SNMPv3,
SNMPv1 & v3: the SNMP agent supports SNMPv1 and SNMPv3.
Default is Disabled: the SNMP agent is not started.
SNMPv1 Community name
User-defined SNMPv1 community name.
Maximum 26 characters.
SNMPv1 Community Security Level
Indicates the rights allowed to the SNMPv1 community.
Read-only: the SNMP agent only accepts the GET commands for this community.
Read/write: the SNMP agent accepts the GET and SET commands for this community.
Default is No access: the SNMP agent rejects user using this community.
SNMPv3 USM User Name
User-defined SNMPv3 User-based Security Model (USM) user name.
Maximum 31 characters.
SNMPv3 USM User Access Rights
Indicates the rights allowed to the SNMPv3 USM user.
Read-only: the SNMP agent only accepts the GET commands for this user.
Read/write: the SNMP agent accepts the GET and SET commands for this user.
Default is No access: the SNMP agent rejects the user.
Table 11. Network Management Card Settings (Continued)
Name
Description