Serial Interface Operation
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
85
9.
Choose one of the following the protocols:
l
Disabled
: The trap receiver is disabled. No trap is sent to this user. Type
0
and press [Enter].
l
SNMPv1
: Traps are sent over SNMPv1 protocol. (It must be compliant with the SNMP version defined
in “Enable/disable the SNMP Agent” on page 82.) Type
0
and press [Enter].
l
SNMPv3
: Traps are sent over SNMPv3 protocol. (It must be compliant with the SNMP version defined
in “Enable/disable the SNMP Agent” on page 82.) Type
0
and press [Enter].
10. Type the name to identify the trap receiver and press [Enter]. This value is not used to send traps.
Get/Set the MIB objects
Read/write access to the MIB objects is ruled by the enabled SNMP version. To get and set the MIB objects:
1.
Configure the SNMP version (see “Enable/disable the SNMP Agent” on page 82).
2.
If required, configure the SNMPv1 users (see “Define SNMPv1 Users” on page 82).
3.
If required, configure the SNMPv3 USM users (see “Define SNMPv3 User-based Security Model Users”
on page 82).
Table 17 summarizes the privileged operations that are allowed according to the SNMP version.
Configure the Ethernet Link Speed and Duplex Mode
By default, the Ethernet link speed and duplex mode is configured on “auto-negotiation” which means the
Network Management Card adapts its Ethernet speed and duplex mode to the network on which it is
connected. However, it is possible to force the following modes:
l
Auto-negotiation
l
100 Mbps Full Duplex
l
100 Mbps Half Duplex
l
10 Mbps Full Duplex
l
10 Mbps Half Duplex
1.
Access the Serial interface and log in.
2.
Type
1
(Network Management Card Settings) and press [Enter].
3.
Type
2
(Network Settings) and press [Enter].
4.
Type
3
(Communication Control) and press [Enter].
NOTE
To receive the test trap #53, the trap receiver must be configured with a protocol
compliant with the one defined in “Enable/disable the SNMP Agent” on page 82.
Table 17. Privileged Operations Allowed for SNMP Version
Disabled
SNMP
v1
SNMP
v3
SNMP
v1 & v3
Privilege
Get
Set
Get
Set
Get
Set
Get
Set
SNMP
v1 User with No Access rights
–
–
–
–
–
–
–
–
SNMP
v1 User with Read-Only rights
–
–
•
–
–
–
•
–
SNMP
v1 User with Read/Write rights
–
–
•
•
–
–
•
•
SNMP
v3 User with No Access rights
–
–
–
–
–
–
–
–
SNMP
v3 User with Read-Only rights
–
–
–
–
•
–
•
–
SMPv3 User with Read/Write rights
–
–
–
–
•
•
•
•