Serial Interface Operation
Eaton Advanced ePDU User’s Guide P-164000042—Rev 1
www.eaton.com/ePDU
87
12. Type
Y
and press [Enter]. The Network Management Card restarts.
Figure 62. IPv4 Configuration
Configure the IPv6 Settings
By default, the SSL encryption is disabled.
1.
Access the Serial interface and log in.
2.
Type
1
(Network Management Card Settings) and press [Enter].
3.
Type
2
(Network Settings) and press [Enter].
4.
Type
2
(IPv6 Configuration) and press [Enter].
5.
Type
1
(IPv6 Control) and press [Enter].
6.
Type
1
(Enabled) and press [Enter].
7.
Type
2
(IPv6 Auto-Configuration) and press [Enter].
8.
Select one of the following configuration methods for IPv6 settings:
l
For manual configuration, type
0
(Disabled) and press [Enter].
Continue to Step 9.
l
For auto configuration, type
1
(Enabled) and press [Enter].
Continue to Step 15.
9.
Type
3
(IPv6 Global Address 1) and press [Enter].
10. Type the IPv6 global address and press [Enter].
11. Type
4
(IPv6 Global Prefix 1) and press [Enter].
12. Type the IPv6 global prefix
1
and press [Enter].
NOTE
Regardless of the configuration you choose, the local IPv6 address is
auto-generated by the Network Management Card.
NOTE 1
For manual configuration, provide the IPv6 global address with its prefix length and
the IPv6 address of the gateway (if any).
NOTE 2
For auto-configuration, the global IPv6 addresses and prefix lengths are
automatically configured by the network (an IPv6 router is required). The gateway
IPv6 address is defined by the user.