Title
Callisto 5PX G2 Service Manual
Checked
:
Rev:
Approved
:
Confidential
Page 52 of 60
This specification is the property of Eaton Corp. and shall not be reproduced or copied or used as the basis for manufacture or sale of apparatus without permission
6 Disassembly
This section defines the exact method to disassemble the UPS for all ratings:
- Screw by Screw: Indicate the locations of the screws on the
frame or on the boards.
- Cables and connectors: identify their connections on the
boards.
- Board references and names.
This permits the reassembly of the UPS and at the same time prevents any errors
of inverted wiring, which could cause the product to break again during switch on.
Example : 5PX 3K HV
Basic steps for Product Disassembly
Step 0: Make sure that the device is disconnected from any power and turned off
for at least one second before disassembling regularly. And then unplug all
external power cords and signal cables from the main body of the device, Make
sure turn off the UPS.
Step 1: Unfix the front panel, disconnect the battery connector, unassembled the
LCD box.
