Parallel-groove terminal (Terminal code - C)
1. Align the circular hole of the spade adapter with the
tapped center hole of the Companion II fuse.
2. Place the internal-tooth lock washer onto the bolt, and
insert the bolt through the spade adapter hole into the
tapped center hole of the fuse (as shown in Figure 8)
and torque the bolt to 10-15 ft-lbs.
3. Assemble carriage bolt, terminal clamp, split lock
washer and hex nut on the spade adapter as shown in
Figure 9.
Spade terminal (Terminal code - D)
1. Align the circular hole of the spade adapter with the
tapped center hole of the Companion II fuse.
2. Place the internal-tooth lock washer onto the bolt and
insert the bolt through the spade adapter hole into the
tapped center hole of the fuse and torque the bolt to
10-15 ft-lbs. (Figure 10.)
Spline stud terminal (Terminal code - G)
1. Insert threaded end of the spline stud into the tapped
center hole of the Companion II fuse and torque spline
stud to 10-15 ft-lbs. (Figure 11.)
Offset adapter (Terminal code - J)
1. Align the hole of the offset adapter with the tapped
center hole of the Companion II fuse.
2. Place the washer onto the bolt and insert the bolt
through the hole of the offset adapter into the tapped
center hole of the fuse and torque the bolt to 10-15
ft-lbs. (Figure 12.)
Figure 9. Parallel-groove terminal.
2.0"
(51 mm)
SPADE
ADAPTER
TERMINAL CLAMP
HEX NUT
CARRIAGE BOLT
BOLT
SPLIT LOCK
WASHER
INTERNAL-
TOOTH
LOCK
WASHER
Figure 10. Spade terminal.
2.0"
(51 mm)
0.41" (10.4 mm)
SQUARE HOLE
BOLT
SPADE
ADAPTER
INTERNAL-
TOOTH
LOCK
WASHER
Figure 11. Spline stud terminal.
2.44"
(62 mm)
Figure 12. Offset adapter terminal.
3.8"
(97 mm)
OFFSET
ADAPTER
0.8"
(20 mm)
BOLT
WASHER
5
COMPANION II BACK-UP CURRENT-LIMITING FUSE INSTALLATION INSTRUCTIONS
MN132009EN
