Product information
Introduction
Service Information MN280055EN covers the periodic
inspection, routine maintenance instructions, testing,
component replacements, and adjustments for Types V4L
and V4E hydraulically controlled, single-phase, vacuum
interrupting reclosers. Service parts lists, keyed to
exploded-view drawings of the unit, along with ordering
information, are included in the manual.
Read this manual first
Read and understand the contents of this manual and
follow all locally approved procedures and safety practices
before installing or operating this equipment.
Additional information
These instructions cannot cover all details or vari ations
in the equipment, procedures, or process described nor
provide directions for meeting every possible contin gency
during installation, operation, or maintenance. For additional
information, contact your Eaton representative.
Acceptance and initial inspection
Each recloser is completely assembled, tested, and
inspected at the factory. It is in good condition when
accepted by the carrier for shipment. Upon receipt, inspect
the shipping container for signs of damage. Unpack the
recloser and inspect it thoroughly for damage incurred
during shipment. If damage is discovered, file a claim with
the carrier immediately.
Handling and storage
Be careful during handling and storage of the recloser to
minimize the possibility of damage. If the recloser is to be
stored for any length of time prior to installation, provide a
clean, dry storage area.
Standards
Eaton’s Cooper Power series reclosers are designed and
tested in accordance with the following standards:
ANSI/IEEE C37.60-1981 and IEEE Std C37.85™-1989
standards and ANSI Guide C37.61-1973.
Quality standards
ISO 9001 Certified Quality Management System.
Types V4L and V4E single-phase maintenance instructions
1
MAINTENANCE INSTRUCTIONS
MN280055EN May 2017
