background image

RLY-800 Radio Frequency Relay (Brazil)

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and receiver. 
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

These devices operate under Part 15 of the FCC rules. Modifications to these devices not expressly authorized by Cooper Power
Systems may affect your ability to legally operate these devices.

DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY

THERE ARE NO UNDERSTANDINGS, AGREEMENTS, REPRESENTATIONS, OR WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THOSE
SPECIFICALLY SET OUT BY ANY EXISTING CONTRACT BETWEEN THE SELLER AND BUYER. ANY SUCH CONTRACT
STATES THE ENTIRE OBLIGATION OF SELLER. THE CONTENTS OF THIS INFORMATION LEAFLET SHALL NOT BECOME
PART OF OR MODIFY ANY SUCH PRIOR OR EXISTING AGREEMENT.

The information, recommendations, descriptions, and safety notations are based on Cooper Power Systems experience and
judgment. THIS INFORMATION SHOULD NOT BE CONSIDERED AS ALL-INCLUSIVE OR COVERING ALL CONTINGENCIES.
If further information is required, Cooper Power Systems should be consulted. In no event will Cooper Power Systems be
responsible to the user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental,
or consequential damage or loss whatsoever; or claims against the user by its customers resulting from use of information,
recommendations, descriptions, or safety notations.

One Cooper | www.cooperpower.com | Online

Copyright © 2013 Eaton. All rights reserved.

Eaton, Cooper Power Systems and Yukon are valuable trademarks of

Eaton in the U.S. and other countries. You are not permitted to use Eaton

trademarks without the prior written consent of Eaton.

CT-Y0-0556 REV1

!

SAFETY

FOR LIFE

Summary of Contents for Cooper Power Systems RLY-800















Reviews: