Effective 10/00
Page 5
IL 33-K2C-3
Before Beginning the Retrofit Process
Identify the Breaker and the Retrofit Kit
It is important to verify exactly which version of ITE
K-Line Breaker(s) is to be Retrofitted and to insure
that the correct Cutler-Hammer Retrofit Kit(s) was
ordered. Each Breaker must be identified using all
of the following sources:
1. Name Plate Information;
2. Back Plate Color;
3. Type of Finger Clusters
(Rectangular or Round); and
4. Fuse Use and Configuration
(Horizontal or Vertical).
Please refer to the following table and verify that
the first three (3) characters of the Retrofit Kit
Code Number correspond to the Breaker being
Retrofitted.
Following the Icons to a Successful Retrofit
During certain parts of the Retrofit Process, proce-
dures may differ depending on the version of the
Breaker being Retrofitted. To enable the Retrofitter
to quickly identify the correct procedures for the
Breaker, Icon(s) will appear. Simply follow only the
instructions identified by the Icon for the Breaker
being Retrofitted.
Breaker
Back Plate
Desired Sensor
Finger Cluster
Fuse
Fuse
Retrofit
ICON
Rating
Color
1
Location
Type
Location
Configuration
Kit Code
Non-Fused
K-1600
Black
Top
Rectangular
None
N.A.
K1C
K-1600
Red
Top
Rectangular
None
N.A.
K2C
K-2000
Red
Top
Round
None
N.A.
K2D
Top Mounted Horizontal and Vertical Fused
KDON-
Black
2
Bottom
Rectangular
Top
Horizontal
K6C
1600
or Vertical
KDON-
Red
Bottom
Rectangular
Top
Horizontal
K4C
1600
or Vertical
KDON-
Red
Bottom
Round
Top
Horizontal
K7C
1600
or Vertical
Bottom Mounted Horizontal Fused
KDON-
Black
2
Top
Rectangular
Bottom
Horizontal
K1C
1600
KDON-
Red
Top
Rectangular
Bottom
Horizontal
K2C
1600
KDON-
Red
Top
Round
Bottom
Horizontal
K5C
1600
NOTES:
1. Black or Red refers to the color of the Breaker Back Plate.
2. If specified during ordering, special Trip Unit Brackets have been supplied for some older models of the
KDON-1600 Black Breaker equipped with trigger fuses. If the Brackets are needed but were not ordered,
contact Cutler-Hammer at: 1-800-937-5487.
GENERAL NOTE
:
If the existing Breaker components mandate that the new DTA, supplied with the Retrofit Kit, be mounted inside the
Breaker on the right side instead of the left, as detailed in these instructions, contact Cutler-Hammer at: 1-800-937-5487
to obtain the special parts required. See Step 4 for details.
Table 2
Identifying the K-Line Breaker
www
. ElectricalPartManuals
. com
