5 Application example
5.1 General
DX-NET-PROFINET2-2
01/22 MN040062EN
www.eaton.com
99
5 Application example
5.1 General
This chapter describes how communication is established between a
Siemens PLC and the DX-NET-PROFINET2-2 via PROFINET.
The main section of this chapter describes how to access the process and
parameter data of the variable frequency drive.
￫
The description is intended for experienced drive specialists and
automation technicians.
Basic knowledge of the PROFINET communication system and
the programming of a PROFINET controller is required.
In addition, knowledge of handling the drive is required.
We also assume that you have a good knowledge of the techni-
cal basics and are familiar with the handling of electrical equip-
ment and machines as well as reading technical drawings.
Please read this chapter carefully before installing and operating
the PROFINET connection.
￫
Please also observe the information in the operating instructions
for the variable frequency drive/variable speed starter.
