4 Commissioning
4.12 Acyclic data
DX-NET-PROFINET2-2
01/22 MN040062EN
www.eaton.com
63
4.12.3 Parameter list
The following table lists all parameters that must be processed acyclically via
PROFINET.
The abbreviations and acronyms used in the overview are defined below:
Table 43:
Abbreviations
The “Parameter number in specific device” column is subdivided into three
sub-columns, one for each PowerXL device (DC1, DE1).
When there is a parameter number in the sub-column for a device, this
means that the parameter is available on that device. The parameter will
have the exact same function on all device types.
A check mark
✓
indicates that this parameter is present in the device but
does not have a parameter number.
A minus sign ( – ) means that the parameter is not available on the device.
Abbreviation
Meaning
PNU
Parameter number; parameter designation used by the drivesConnect parameter software and
the external DX-KEY-LED keypad's display.
PNU Subindex
Parameter number subindex
RUN
The parameter can be accessed during operation (Run signal)
STOP
The parameter can only be accessed in STOP mode
ro/rw
Parameter read and write permissions:
ro = read only
rw = read and write
Name
Short parameter name
Value
• Setting value of the parameter
• Value range
• Display value
Default
Default setting (the parameter's value when using the device's factory settings)
The values in parentheses are the default settings when using a frequency of 60 Hz.
￫
For more detailed information on the individual parameters,
please refer to the manuals for the corresponding basic devices.
