83
The identification menu
By press
on the menu of “Identification”, the display would enter the
next identification menu tree.
The identification information includes UPS serial number, firmware serial
number, model type, would be shown here.
By press ESC >300ms, the display would return the last main menu tree.
The setting menu
Please contact your local distributor for further information before
using the settings. Some settings would be changed the specification,
and some settings would enable or disable some functions. The
unsuitable option setting by user may result in potential failures or
protecting function loss, even directly damage the load, battery or
UPS.
AH setting could be set via RS232 or USB communication. Default AH
setting is disabled.
Most of settings could only be done while UPS is in Bypass mode.
Summary of Contents for DXRT 10KS31-IN Series
