93
Fault code: F808
Fault lamp lights long,
Beep continuous.
UPS has transferred to
bypass or fault mode
because of overload in
inverter mode
The UPS transfers to Battery
mode if supporting the load.
Remove some of the
equipment from the UPS
Fault code: F208
Fault lamp lights long,
Beep continuous.
UPS has cut off the
output and transferred
to fault mode because
of overload in bypass
Remove some of the
equipment from the UPS
Fault code: A900
Fault LED is flash
1 beep every 1 second
An overload or a fault
has occurred, or a
command has been
received and the UPS is
in Bypass mode
Please contact your supplier
Fault code: F806
Fault lamp lights long,
Beep continuous.
Shut down in
emergency
Please check EPO terminal
status.
Fault code: F004
Fault lamp lights long,
Beep continuous.
The UPS internal heat
sink temperature is too
high or a fan has failed.
At the warning level,
the UPS generates the
alarm but remains in
the current operating
state.
If the temperature rises
another 2°C, the UPS
transfers to Bypass
mode or Standby
mode.
Clear vents and remove any
heat sources. Allow the UPS to
cool. Ensure the airflow
around the UPS is not
restricted. Restart the UPS.
If the condition continues to
persist, contact your service
representative.
Fault code: A004
Fault LED is flash
1 beep every 1 second
Alarm because of UPS
internal heat sink
temperature is too high.
Please contact your supplier
Fault code: A004
Fault LED is flash
1 beep every 1 second
Alarm because of
ambient temperature
high.
Check if the ambient
temperature exceed 50°C. if it
is normal,
please contact your
supplier
Fault code: A007
Fault LED is flash
1 beep every 1 second
Fans blocked
Please contact your supplier
Summary of Contents for DXRT 10KS31-IN Series
