Eaton Electric Vehicle Power Charging Station MODBUS Device E2 Setup for 527-0354
Document Part # 026-4913 Rev 1 28-SEP-2011
Page 2 of 11
©2011 Emerson Climate Technologies, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.
quick start guide
STEP 2: Activate the license of the device.
5. From the E2 front panel (or via Terminal Mode), press
,
7
(System Configuration),
and
9
(Licensing).
6. Press
F1
(ADD FEATURE) and enter your license key.
STEP 3: Once the license is activated, add the device to the E2 controller.
7. Press
,
7
(System Configuration),
7
(Network Setup),
2
(Connected I/O Boards &
Controllers).
8. Press
F2
(NEXT TAB) to go to the C4: Third Party tab. You should see the device in the list.
Enter the number of devices to add and press the
button to save your changes.
STEP 4: Assign the MODBUS port.
9. Press
,
7
(System Configuration),
4
(Remote Communications),
3
(TCP/IP Setup).
Figure 2 - Add License Screen
