3 Commissioning
3.8 The first circuit diagram
80
Control Relay easy800
11/11 MN04902001Z-EN
www.eaton.com
From the first contact to the output coil
With easy800 devices wire from the input to the output. The first input
contact is
I01
.
▶
Press OK
.
easy800 proposes the first contact
I01
at the cursor position.
I
flashes and can be changed, for example, to a
P
for a pushbutton input
using the cursor buttons
Í
or
Ú
. However, nothing needs to be changed at
this point.
▶
Press OK twice, to move the cursor across the
01
to the second contact
field.
You could also move the cursor to the next contact field using the cursor
button.
▶
Press OK.
Again, inserts easy800 a contact
I01
at the cursor position.
▶
Press OK so that the cursor jumps to the next position and press cursor
button
Í
or
Ú
to change the number to
02
.
▶
Press OK to move the cursor to the third contact field.
You do not need a third relay contact, so you can now wire the contacts
directly up to the coil field.
Wiring
easy800 device displays a small arrow
l
in the circuit diagram when creating
the wiring.
Press ALT
to activate the wiring arrow cursor and use the cursor buttons
Í
Ú
ú
í
to move it. Pressing ALT once more switches the cursor back to Move
mode.
I01
L: 1 C:1 B:7944
I01
Ê
L: 1 C:1 B:7944
I01 I01
L: 1 C:2 B:7944
￫
Press DEL to delete a contact at the cursor position.
-I02
Ê
L: 1 C:3 B:7944
￫
ALT also has two other functions depending on the cursor
position:
•
In the left contact field, you can press ALT to insert a new
empty circuit connection.
•
The contact under the cursor can be changed between a
N/O and N/C contact by pressing the ALT button.
