4 Wiring with 800
4.5 Working with contacts and coils
Control Relay easy800
11/11 MN04902001Z-EN
www.eaton.com
113
4.5.3 Entering and changing coils
With a relay coil or a function block, you choose the coil function, coil name,
coil number as well as the function block coil. With coils of an easyNet
station, choose the address (NET ID) in front of the coil name.
Example: Relay coil “Output Q“
Example: Relay coil for timing relay function block with control coil
Example: Relay coil of a NET station
Values for contacts and coil fields are changed in Entry mode. The value to
be changed flashes.
▶
Use
ú í ÍÚ
to move the cursor to a contact or coil field.
▶
Press OK to switch to Entry mode.
▶
Use
ú í
to select the position you wish to change and press OK to move
to the next position (a selected position is shown in light grey in the
following figure).
▶
Use
ÍÚ
to modify the value of the position.
￫
The coil number in the figures on the left must be the same as
the function block number!
S Q 04
Coil function
Coil name
Coil number
Ä
T 04EN
Coil function
Coil name
(= function block name)
Coil number
Function block coil
S2SN04
Coil function
Station address
Coil number
Coil name
￫
A complete list of all contacts and coils,
section 12.8, “List of function blocks”, page 369.
I
01
￫
The easy800 device proposes contact
I 01
or the coil
Ä
Q 01
for
entry in an empty field.
